EPSON Stylus COLOR 440, 640, and 740
4.2.4.2 Removing the Waste Ink Pad Assembly
1. Remove the housing. (Refer to
2. Remove the 1 screw (No.4) securing the waste ink pad assembly to
the frame on the lower-right side of the printer.
3. While pulling down on the right side of the waste ink pad assembly,
pull out the locking plate on the left. Then remove the assembly.
C A U T I O N
When installing the waste ink pad assembly, be sure to
replace the locking plate.
Section
4.2.1.)
Chapter 4 Disassembly and Assembly
Figure 4-8. Removing the Waste Ink Pad Assembly
98