Waste Ink Tray; Waste Ink Pad - Epson Stylus Photo R280 Service Manual

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50

4.4.5 Waste Ink Tray

Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Upper Housing / Main Board Unit / Panel Assy /
Cover Open Sensor / Printer Mechanism
Removal procedure
When removing the Waste Ink Tray, take extra care not to spill
C A U T I O N
ink and contaminate the printer and surroundings.
1. Remove the two screws, disengage the hook, and remove the Waste Ink Tray.
Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
•
Waste Ink Tray
Hook
Figure 4-61. Removing the Waste Ink Tray
Whenever the Waste Ink Tray is replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
• Refer to "5.1.2 Required Adjustments" (p.107)
Chapter 4 Disassembly/Assembly
(No.4)
4.4.5 Waste Ink Tray (Disassembling the Printer Mechanism)

4.4.6 Waste Ink Pad

Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Upper Housing / Main Board Unit / Panel Assy /
Cover Open Sensor / Printer Mechanism
Removal procedure
When removing the Waste Ink Pad, take extra care not to
C A U T I O N
contaminate the printer and surroundings with ink.
Be careful of the seven sharp edges shown in
disassembling or reassembling.
1. Remove the three Waste Ink Pads from the trays.
Figure 4-62. Removing the Waste Ink Pad
Insert the Waste Ink Pads into the trays inserting the slits of the
pads over the tabs
far as they will go (until their top surface locate lower than the top
surface of the tray edges).
Tab
Figure 4-63. Installing the Waste Ink Pad
Revision C
Fig.4-62
Sharp edge
Waste Ink Pad
on the trays. Make sure to push the pads as
Slit
Confidential
when
80