Middle Housing - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390

4.3.6 Middle Housing

Parts/Components need to be removed in advance
All exterior parts/components / Card Board (USB Board) / Main Board Unit
Removal procedure
Refer to the Orientation Definition below for the directions
indicated in the following procedures.
"4.1.6 Orientation Definition (p.61)"
•
1. Remove the two screws.
Screw : C.B.S. M3x10 (tightening torque: 5-7 kgf.cm)
•
(The numbers shown in the figure indicate the order of tightening the screws.)
Middle Housing
1
Figure 4-79. Removing the Middle Housing (1)
Disassembly/Assembly
2. Remove the Middle Housing taking extra care not to get the FFC caught on
the opening part.
3. Disengage the hook from the hole of the rib, and remove the Left Ground
Plate MB.
Front Frame
4. Remove the Right Ground Plate MB.
2
Removing Control Boards
Removal Direction
Opening
Figure 4-80. Removing the Middle Housing (2)
Left Ground Plate MB
Removal Direction
Disengage the
hook
Figure 4-81. Removing the Middle Housing (3)
Tighten the screws in the order given in Fig.4-79.
After installing the Middle Housing, check that the Left/Right
Ground Plates MB are properly grounded.
Revision B
Head FFC
Middle Housing
Right Ground Plate MB
86