Powering Off The Subsystem - Asus DS300i User Manual

Powering Off the Subsystem

You can only do part of this function in Smart NAS Console. Additional action is
required, as described below.
To power off the subsystem:
1. Click the NAS Management icon at the top of the screen.
The Shutdown icon at the bottom of the screen is automatically selected.
2. Click the Power Off option button.
3. Click the OK button.
When the controller shuts down, your Smart NAS Console connection is lost.
4. Wait for no less than two minutes.
5. Unplug the power cord or cords, then plug them back in, to activate the
power switches.
Monitoring the Power-Off
To monitor a power-off, you must use the Command Line Interface (CLI) though a
serial connection to the ASUS Storage.
Turn off both power supply switches when the following this message appears:
Shutdown complete. It is now safe to power off the subsystem.
Shutting Down the Subsystem
You can only do part of this function in Smart NAS Console. Additional action is
required, as described below.
1. Click the NAS Management icon at the top of the screen.
If you have a JBOD expansion, always power off the RAID
subsystem first. Then power off the JBOD expansion units.
After you power-off the subsystem, wait at least 10 seconds
before you power-on the subsystem again.
If you have a JBOD expansion, always power-off the RAID
subsystem first. Then power-off the JBOD expansion units.
Important
Caution
Important
199
Chapter 5: SmartNAVI