Unsaved Data In The Controller Cache; Asus Storage Does Not Boot - Asus DS300i User Manual

User manual
Hide thumbs Also See for DS300i:
Table of Contents

Advertisement

1 1
1 1
1 2
1 3
1 4
The new management port IP address and other network settings are
displayed on the screen.
Enter the new IP address into your browser to log into ASUS Storage
Management.

Unsaved Data in the Controller Cache

The Dirty Cache LED informs you that there is data in the cache that has not
been saved to non-volatile memory. Such data is sometimes called ―dirty,‖ not to
suggest it is corrupted in some way but because it has not been saved to a disk
drive.
Figure 23. Dirty Cache LED
If there is unsaved data in the controller's cache, the Dirty Cache LED shines
amber. During this time, do NOT power down the ASUS Storage. Wait until the
LED goes dark.

ASUS Storage Does Not Boot

The most common cause of a ASUS Storage not booting is when power to the
subsystem was interrupted during a firmware flash.
See ―Chapter 8: Maintenance‖ on page 305 for more information about firmware
flashing.
If Rescue Mode is enabled and you have a USB drive with a boot partition, you
can boot the ASUS Storage from the USB drive.
1.
Power down the ASUS Storage.
2.
Attach the USB drive.
3.
Power up the ASUS Storage.
Mgmt 192.168.10.85 255.255.255.0 192.168.10.1
iSCSI
192.168.10.88 255.255.255.0 192.168.10.1
iSCSI
192.168.10.89 255.255.255.0 192.168.10.1
iSCSI
192.168.10.90 255.255.255.0 192.168.10.1
iSCSI
192.168.10.91 255.255.255.0 192.168.10.1
Dirty Cache LED
397
Chapter 10: Troubleshooting
Up
Up
Up
Up
Up

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ds300f

Table of Contents