Table of Contents
Advertisement
Restarting the Subsystem
There are two methods for shutting down the subsystem, depending on your
connection. Choose the applicable procedure:
•
Restarting the Subsystem (page 280)
•
Restarting ASUS Storage – Serial Connection (page 280)
Restarting ASUS Storage – Telnet Connection
This function enables you to restart the ASUS Storage subsystem on a Telnet
connection. You can only do part of this procedure in the CLU. Additional action is
required, as described below.
To restart the ASUS Storage:
1.
From the Main Menu, highlight Additional Info and Management and press
Enter.
2.
Highlight Shutdown or Restart and press Enter.
3.
Highlight Option and press the spacebar to display Restart.
4.
Highlight Submit and press Enter.
A warning message appears.
5.
Press Y to continue.
The screen goes blank.
6.
Wait for no less than two minutes.
7.
Re-establish your Telnet connection to the ASUS Storage CLU.
If you cannot re-establish a connection, wait 30 seconds, then try again.
Restarting ASUS Storage – Serial Connection
This function enables you to restart the ASUS Storage subsystem on a serial
connection. You can only do part of this procedure in the CLU. Additional action is
required, as described below.
To restart the ASUS Storage:
1.
From the Main Menu, highlight Additional Info and Management and press
Enter.
2.
Highlight Shutdown or Restart and press Enter.
3.
Highlight Option and press the spacebar to display Restart.
If you have a JBOD expansion, you are not required to restart the
JBOD expansion units when you restart the RAID subsystem.
Chapter 6: Management with the CLU
Note
280
Advertisement
Table of Contents
