Table of Contents
Advertisement
Figure 8. Removing the RAID Controller
2.
Lay the RAID controller on a non-static surface and remove the cover
attaching screws, one on each side, then remove the cover.
See page 315, Figure 5.
3.
Gently press the retainers outward until the memory module pops out of the
memory slot.
Figure 9. RAID controller memory module
Retainer
4.
Align the new memory module with the memory slot so the groove lines up.
5.
Gently press the memory module into the slot until the retainers click into
locked position.
6.
Attach the RAID controller cover and install the two attaching screws.
See page 315, Figure 5.
7.
Reinstall the RAID Controller.
See ―Replacing a RAID Controller‖ on page 312.
This completes the memory module replacement procedure.
Thumbscrew
Memory
Alignment
module
groove
317
Chapter 8: Maintenance
Latch
Memory
Retainer
slot
Advertisement
Table of Contents
