Cmc Setup For Remote Support - HP StorageWorks P4000 User Manual

NOTE:
Control which storage systems appear in the navigation window by entering only specific IPs in the
Find Systems window. Then, when you open the CMC, only those IPs or Host Names will appear in
the navigation window. Use this method to control which management groups appear.

CMC setup for remote support

If you are using HP remote support, the table below lists the CMC setup required for remote support.
Table 5 CMC setup for remote support
Requirement
SNMP enabled on each storage system
SNMP trap recipient set to IP address of the system where
the remote support client is installed
Port 8959 (used for the CLI) open
Management group login and password for a read-only
(View_Only_Administrator group) user
For more information, see
"Enabling SNMP agents" on page 130
"Adding SNMP traps" on page 133
Your network administrator
"Adding a new administrative
115
P4000 SAN Solution user guide
user" on page
37