Create A New Smartclone Volume From The Snapshot; Roll Back All Associated Volumes; New Volume With Shared Clone Point - HP StorageWorks P4000 User Manual

Create a new SmartClone volume from the snapshot

Instead of continuing with a standard roll back, you can create a new SmartClone volume, with a
new name, from the selected snapshot. This choice preserves any newer snapshots and any new data
in the original volume.
1. Click New SmartClone Volume.
2. Enter a name, and configure the additional settings.
For more information about characteristics of SmartClone volumes, see
volume characteristics" on page 237.
3. Click OK when you have finished setting up the SmartClone volume and updated the table.
The new volume appears in the navigation window, with the snapshot now a designated clone
point for both volumes.
4. Assign a server, and configure hosts to access the new volume, if desired.
1. Original volume
2. New SmartClone volume from snapshot
3. Shared clone point
Figure 80 New volume with shared clone point
.
5. If you created the SmartClone from an application-managed snapshot, use diskpart.exe to change
the resulting volume's attributes.
For more information, see

Roll back all associated volumes

The recommended method for rolling back a snapshot that is part of a snapshot set is to roll back
each volume to its corresponding snapshot. For more information about snapshot sets, see
"Understanding snapshots for volume
"Making an application-managed snapshot
sets" on page 216.
"Defining SmartClone
available" on page 218.
P4000 SAN Solution user guide 229