Configuring Administrative Users; Configuring A Network Connection - HP StorageWorks P4000 User Manual

NOTE:
This user is viewable in the CMC under the management group Administration category.

Configuring administrative users

Use the Configuration Interface to add new administrative users or to change administrative passwords.
You can only change the password for the administrative user that you used to log in to the
Configuration Interface.
1. On the Configuration Interface main menu, tab to General Settings, and press Enter.
2. To add an administrative user, tab to Add Administrator, and press Enter. Then enter the new
user's name and password. Confirm password, tab to Ok, and press Enter.
3. To change the password for the user that you are currently logged in as, tab to Change Password,
and press Enter. Then enter the new password. Confirm password, tab to Ok, and press Enter.
4. On the General window, tab to Done, and press Enter.

Configuring a network connection

The storage system comes with two Ethernet interfaces.
are labeled and the label name.
Table 69 Identifying Ethernet interfaces on the storage system
Ethernet Interfaces
Where labeled
TCP/IP Network configuration category in
the CMC
• TCP/IP tab
• TCP Status tab
Configuration Interface
Label on the back of the storage system
Once you have established a connection to the storage system using a terminal emulation program,
you can configure an interface connection using the Configuration Interface.
1. On the Configuration Interface main menu, tab to Network TCP/IP Settings, and press Enter.
2. Tab to select the network interface that you want to configure, and press Enter.
Table 69 on page 307 lists where interfaces
What the label says
Name:
eth0, eth1
Motherboard:Port0, Motherboard:Port1
G4-Motherboard:Port1, G4-Motherboard:Port2
Motherboard:Port1, Motherboard:Port2
Intel Gigabit Ethernet or Broadcom Gigabit Ethernet
Eth0, Eth1, or a graphical symbol similar to the following:
or
P4000 SAN Solution user guide 307