Opening The Configuration Interface From The Terminal Emulation Session; Logging In To The Configuration Interface; Configuring Administrative Users; Configuring A Network Connection - HP StoreVirtual 4000 User Manual

$ xterm
3. In the xterm window, start minicom as follows:
$ minicom -c on -l NSM

Opening the Configuration Interface from the terminal emulation session

1. Press Enter when the terminal emulation session is established.
2. Enter start, and press Enter at the log in prompt.
3. When the session is connected to the storage system, the Configuration Interface window
opens.

Logging in to the Configuration Interface

Once you have established a connection to the storage system, log in to the Configuration Interface.
Table 73 Logging in depends on where the storage system is
If the storage system is in
Available Systems pool
Management group
NOTE: This user is viewable in the CMC under the management group Administration category.

Configuring administrative users

Use the Configuration Interface to add new administrative users or to change administrative
passwords. You can only change the password for the administrative user that you used to log in
to the Configuration Interface.
1. On the Configuration Interface main menu, tab to General Settings, and press Enter.
2. To add an administrative user, tab to Add Administrator, and press Enter. Then enter the new
user's name and password. Confirm password, tab to OK, and press Enter.
3. To change the password for the user that you are currently logged in as, tab to Change
Password, and press Enter. Then enter the new password. Confirm password, tab to OK, and
press Enter.
4. On the General window, tab to Done, and press Enter.

Configuring a network connection

The storage system comes with two Ethernet interfaces.
are labeled and the label name.
Table 74 Identifying Ethernet interfaces on the storage system
Ethernet Interfaces
Where labeled
TCP/IP Network configuration category in the CMC
TCP/IP tab
TCP Status tab
240 Using the Configuration Interface
From Configuration Interface entry window
Press Enter to log in. The Configuration Interface main menu
opens.
1. Press Enter to log in.
2. Enter the user name and password of the administrative
user created for the management group.
3. Tab to Login, and press Enter.
Table 74 (page 240)
What the label says
Name:
eth0, eth1
Motherboard:Port0, Motherboard:Port1
G4-Motherboard:Port1, G4-Motherboard:Port2
lists where interfaces