Tools Required; Removing The Memory Board - HP D5970A - NetServer - LCII User Manual

Chapter 5

Tools Required

To remove or install a memory board, first remove the satellite chassis lower fan
module and the rear access panel. These tools are required for removal and
installation of accessories:
Number 1 Phillips head screwdriver
An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.

Removing the Memory Board

To remove the memory board, follow this procedure:
1. Power down the HP NetServer. See Chapter 2 for details.
2. Open the HP NetServer's lower board cage, which holds the memory
board(s). To do this, you must extend the satellite chassis, and then
remove the satellite's lower fan module and rear access panel. See
Chapter 3 for details.
3. After removing the rear access panel, locate the existing 4 GB memory
board. See Figure 5-4.
4. On the memory board, open the two retaining clips toward you.
38
Installing Additional Memory