3.
Pull open the access panel handle (1).
Figure 4-7
4.
Slide the access panel toward the rear of the workstation and lift off the cover (2).
Replacing the side access panel
To replace the side access panel:
1.
Place the access panel over the chassis and align the tabs along the edges of the access panel
with the slots in the chassis.
2.
Press the access panel down, fitting the tabs into the slots.
3.
Slide the access panel toward the front of the chassis until it locks into place.
Figure 4-8
Hood Sensor (Smart Cover Sensor) (optional)
This section describes how to remove the Hood Sensor.
ENWW
Removing the access panel
Installing the access panel
Removing and replacing components
65