HP Visualize J5000 - Workstation Handbook page 67

Table 3-1. Chassis Codes for J5000 and J7000 Workstations
Ostat Code FRU
WRN 7601 DIMM
TST 7602 DIMM
TST 7603 DIMM
TST 7604 DIMM
TST 7605 DIMM
TST 7606 DIMM
TST 7607 DIMM
TST 7608 DIMM
TST 7609 DIMM
TST 760A DIMM
TST 760B DIMM
WRN 760C DIMM
FLT 760D DIMM
FLT 7610 DIMM
FLT 7611 DIMM
FLT 7612 DIMM
FLT 7613 DIMM
FLT 7614 DIMM
FLT 7800 SYS BD
FLT 7801 SYS BD
Chapter 3
Message
mem init only
tst 1st mem page
tst rest of mem
start 1st pass
1st pass x %
start 2nd pass
2nd pass x %
start 3rd pass
3rd pass x %
start mem init
mem init x %
repeat dest test
mem code cpy err
ECC wrt/read err
ECC single data
ECC single ECC
ECC multipl data
ECC multpl signl
mem err summary
bus ctrl par err
Identifying LCD-Indicated Conditions
Description
Skip the test, just initialize memory to
save time.
Starting 3-pass test of first memory page.
Starting 3-pass test of the rest of memory.
Starting 1st pass of memory test (write
pseudorandom sequence).
First pass is x% complete.
Starting 2nd pass of memory test (verify
pseudorandom sequence, write inverse).
Second pass is x% complete.
Starting 3rd pass of memory test (verify
inverse sequence).
Third pass is x% complete.
Starting memory initialization. (Initialize
to zero to set ECC.)
Memory initialization is x% complete.
Re-execute destructive test for hardware
troubleshooting.
Firmware tried to copy code from ROM to
memory, but the copy didn't match the
original.
Writing and reading back good data
caused memory ECC error.
Memory ECC test failed to detect
single-bit data error.
Memory ECC test failed to detect
single-bit ECC error.
Memory ECC test failed to detect
multiple-bit data error.
Memory ECC test failed to signal
multiple-bit error.
Printing memory error summary word to
RS-232 if in manufacturing mode or if the
chassis jumper is installed.
System bus (Runway) control parity error
detected.
Troubleshooting
63