Figure 2-2. Dds-3 Tape Drive Nse Scsi-2 Id/Jumper Settings - HP Visualize J5000 - Workstation Handbook
Workstations
Hide thumbs
Also See for Visualize J5000 - Workstation:
- Supplementary manual (214 pages) ,
- Owner's manual (212 pages) ,
- Service handbook (172 pages)
Table of Contents
Advertisement
Configuration
Field Replaceable Unit (FRU) Configurations
DDS-3 Tape Drive (Optional) Configuration
Figure 2-2 shows the NSE SCSI-2 ID/jumper settings for the optional DDS-3 tape drive.
Figure 2-3 shows the switch settings for Data Compression Operation Mode for the DDS-3
tape drive.
See the section titled "DDS-3 Tape Drive (Optional)" on page 95 for details on installing a
DDS-3 tape drive.
Figure 2-2. DDS-3 Tape Drive NSE SCSI-2 ID/Jumper Settings
Bit 0
Bit 1
Bit 2
Term PWR*
SCSI Connector
Power Connector
* Term PWR is not used in HP workstation configurations.
36
Chapter 2
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Visualize J5000 - Workstation and is the answer not in the manual?
Questions and answers