Terminators; Scsi Configuration Constraints - HP Visualize J5000 - Workstation Handbook
Workstations
Hide thumbs
Also See for Visualize J5000 - Workstation:
- Supplementary manual (214 pages) ,
- Owner's manual (212 pages) ,
- Service handbook (172 pages)
Table of Contents
Advertisement
Terminators
The terminators for NSE and LVD SCSI are different. The NSE terminator has 50 pins
and will fit on an NSE connector only. The LVD terminator has 68 pins and will fit on an
LVD connector only. The following SCSI terminators are shipped with the J5000 and J7000
workstation:
• 50-pin NSE terminator (HP Product Number A1658-63012)
• 68-pin LVD terminator (HP Product Number A4986-63008)
NOTE
It is necessary to put a terminator on unused SCSI connectors on the rear
panel of the workstation. Also, a SCSI device attached to the SCSI bus, or the
last external device connected to the SCSI bus, must be terminated with a
SCSI terminator.
SCSI Configuration Constraints
The number of SCSI devices per bus is limited (see Table C-1 earlier in this appendix).
Before adding another SCSI device, determine if the system can support the additional
device.
Appendix C
SCSI Connections
SCSI Restrictions
159
Advertisement
Table of Contents
Troubleshooting
