Figure 1-5. Cd Drive Features; Table 1-2. Cd Drive Features - HP Visualize J5000 - Workstation Handbook

Product Information
Front Panel Components
CD Drive (Optional)
As an optional component, the J5000 and J7000 workstations support one 32X CD drive
with an ATAPI (IDE) interface (Product Number A5001A). The CD drive is a 5.25-inch,
half- height form factor device which connects to the workstation via a 40-pin IDE ribbon
cable, a 4-pin audio cable, and a 4-pin power cable. The CD drive bay is located on the top,
right-hand side of the front panel.
Figure 1-5 shows the operating features of the CD drive, and Table 1-2 describes these
features.

Figure 1-5. CD Drive Features

Indicator

Table 1-2. CD Drive Features

Feature Purpose
Busy Indicator Lights during a data access operation and blinks during a
data transfer. The indicator blinks initially and then stays lit
when there is one of the following:
• A defective disk
• A disk insertion error (for example, an upside-down disk)
• No disk present
Emergency Opens the Disk Tray when the end of a paper clip is inserted
Eject Hole into it. Used when the workstation does not have power and
the Disk Tray cannot be opened by pressing the Eject Button.
Eject Button Opens the Disk Tray so that a CD disk may be inserted in it
or removed from it. When the drive is in use, press the Eject
Button for more than one second to open the Disk Tray. The
Disk Tray does not open if the workstation power is off.
Disk Tray Holds the CD disk. (Note that this style of CD drive does not
use a disk caddy.)
18
Emergency
Eject Hole
Busy
Disk Tray
Eject
Button
Chapter 1