Setting Scsi Ids For A New Hard Disk Drive - HP x4000 Accessory Installation Manual

Setting SCSI IDs for a New Hard Disk Drive

You must assign an unused SCSI ID to your hard disk drive. SCSI IDs
range from 0 to 15 for wide 16-bit SCSI.
SCSI ID 0 is used by the first SCSI hard disk drive. SCSI ID 7 is reserved
for the integrated SCSI controller (see Table 2-1). You should assign an
unused SCSI ID to the second SCSI hard disk drive (SCSI ID 1 is
recommended).
Table 2-1
SCSI ID
0
1
2 - 6
7
8 - 15
The SCSI ID is configured with jumpers on the SCSI hard disk drive.
Refer to the information label on the hard disk drive, or the HP x4000
Technical Reference Guide at
additional details on setting the SCSI ID.
Chapter 2
This manual downloaded from http://www.manualowl.com
SCSI ID Settings
Used By
First SCSI hard drive
Optional second SCSI hard drive
Unused
SCSI controller
Unused
www.hp.com/workstations/support
Installing Accessories
SCSI Hard Drive
, for
39