Tools Required; Exchange And Nonexchange Part Numbers; Table 4-1. Exchange Part Numbers - HP Visualize J5000 - Workstation Handbook

Tools Required

Use the following tools to remove or replace FRUs:
• Light-duty flat blade screwdriver with 6-inch (150 mm) blade
• #1 Posi-Drive screwdriver
• T-10, T-15, and T-20 Torx drivers
• Needle-nosed pliers
• ESD equipment (see the "Electrostatic Discharge (ESD) Precautions" section later in
this chapter for detailed information)

Exchange and Nonexchange Part Numbers

In this chapter we refer to exchange and nonexchange part numbers. You must return
FRUs with exchange part numbers in exchange for replacement FRUs. Do not return
FRUs with nonexchange part numbers – you may discard them.
The following Tables 4-1 and 4-2 list the exchange and nonexchange part numbers,
respectively, for the J5000 and J7000 workstations.

Table 4-1. Exchange Part Numbers

Part Number Description
A4978-69010 PCA system board - J5000
A4978-69001 Power supply 800 W - J5000
A4978-69015 PCA system board - J7000
A4981-69001 Power supply 1,300 W - J7000
A4978-69020 PCA - I/O board
A3862-69501 256 MB SDRAM DIMM
A1658-69027 LVD hard disk drive 9 GB 10K RPM
A1658-69026 LVD hard disk drive 18 GB 10K RPM
C1537-69201 SCSI DDS-3 tape drive
Chapter 4
Field Replaceable Units (FRUs)
Tools Required
81