HP Visualize J5000 - Workstation Handbook page 66

Troubleshooting
Identifying LCD-Indicated Conditions
Table 3-1. Chassis Codes for J5000 and J7000 Workstations
Ostat Code FRU
FLT 7207 DIMM
FLT 7208 DIMM
721 s
INI DIMM
INI 722 s DIMM
INI 723 s DIMM
INI 724 s DIMM
INI 725 s DIMM
FLT 72A s DIMM
FLT 72C s DIMM
INI 7300 SYS BD
WRN 7302 SYS BD
WRN 7306 SYS BD
INI 7307 SYS BD
FLT 7308 SYS BD
FLT 7309 DIMM
FLT 730C SYS BD
INI 730F SYS BD
TST 7400 DIMM
TST 740F DIMM
INI 7500 SYS BD
WRN 7501 SYS BD
FLT 7502 SYS BD
TST 7600 DIMM
62
Message
DIMM table full
no DIMMs found
is DIMM s inst?
???? DIMM in s
128M DIMM in s
256M DIMM in s
512M DIMM in s
DIMM s checksum
DIMM s mismatch
mem config start
mem confg changd
use alt mem conf
interleve memory
PDT is disabled
insufficient mem
mem intrlv fail
mem config done
non-dest mem tst
non-dst tst done
memory reset
mem log clr warn
mem err log fail
dest mem test
Description
The DIMM table is full--cannot add new
type.
SPD didn't find any memory DIMMs.
SPD is checking memory slot s.
SPD found a DIMM in slot s, but can't
determine its size. DIMM will not be used.
SPD found a 128MB DIMM in slot s.
SPD found a 256MB DIMM in slot s.
SPD found a 512MB DIMM in slot s.
DIMM in slot s failed SPD checksum and
will not be used.
DIMM in slot s didn't match the other in
pair. (J7000 only--DIMMs must be in
matched pairs.)
Starting main memory configuration.
Memory physical configuration changed
since last boot.
Memory will be configured from fixed
values, instead of detected DIMMs.
Generating the memory interleave.
Firmware detected bad memory pages,
but the Page Deallocation Table is
disabled.
Insufficient error-free memory to
continue.
Memory interleave generation failed.
Main memory configuration complete.
Starting non-destructive memory test.
Non-destructive memory test complete.
Resetting memory system.
Memory error logs didn't clear on first try.
Firmware could not clear memory error
logs.
Starting the destructive memory test.
Chapter 3