Chapter Overview; Workstation Configurations; Field Replaceable Unit (Fru) Configurations; Internal Storage Devices - HP Visualize J5000 - Workstation Handbook

Configuration

Chapter Overview

Chapter Overview
This chapter contains the following main sections:

• Workstation Configurations

• Field Replaceable Unit (FRU) Configurations

— Internal Storage Devices

— Memory
— I/O Cards
— Monitor-Type Selection
Workstation Configurations
Refer to the HP Workstations Website for a complete list of supported accessories,
peripherals, and operating system versions for the J5000 and J7000 workstations. The
URL for the Website is:
http://hp.unixworkstations.com
Field Replaceable Unit (FRU) Configurations
This section provides information for setting up or changing the configuration of the Field
Replaceable Units (FRUs) for the J5000 and J7000 workstations.
Internal Storage Devices
Hard Disk Drive Configuration
The SCSI IDs for hard disk drives are hard-wired into the SCA Ultra2 Wide LVD SCSI
interfaces in the backplane of the four disk bays within the J5000 and J7000 workstations.
Hence, SCSI IDs do not need to be set for the hard disk drives (up to four) installed in
these workstations. From top to bottom, the pre-set SCSI IDs for hard disk drives are: 6, 5,
4, and 3.
Similarly, no jumpers are installed at the factory, nor is any jumper installation required at
the customer's site, on either of the hard disk drive models that are supported with the
J5000 and J7000 workstations. Both hard disk drive models may be installed as is into
these workstations. See the section titled "Hard Disk Drives" on page 91 for details on
installing hard disk drives.
34 Chapter 2