Processor Cautions; Removing The Processor - HP ProLiant ML30 Gen10 Plus Maintenance And Service Manual

Removing the processor

Installing the processor

Processor cautions

Processor cautions
CAUTION: To avoid damage to the processor or system board, only authorized personnel should attempt to replace or CAUTION:
install the processor in this server.
CAUTION: If installing a processor with a faster speed, update the system ROM before installing the processor. CAUTION:
To download firmware and view installation instructions, see the Hewlett Packard Enterprise Support Center website
CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. CAUTION: THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED. To avoid damage to the socket or processor,
do not touch the contacts.
Removing the processor Removing the processor
Prerequisites Prerequisites
Review the processor cautions .
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Alcohol wipe
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
Hewlett Packard Enterprise Support Center website .
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 76