Removing The Powered Serial Port Caps; Configuring Power To A Serial Port - HP Rp3000 - Point of Sale System Reference Manual
Service reference guide: hp rp3000 point of sale
Hide thumbs
Also See for Rp3000 - Point of Sale System:
- Troubleshooting manual (65 pages) ,
- Hardware reference manual (57 pages) ,
- Quickspecs (39 pages)
Table of Contents
Advertisement
Removing the Powered Serial Port Caps
If the powered serial ports have been configured for power from the factory, they will be covered by
protective plastic caps. Turn off the computer and remove the caps before connecting powered serial
Point of Sale devices.
Figure 6-26
Configuring Power to a Serial Port
The serial ports on the HP Point of Sale System computer can be configured as standard (non-powered)
serial ports or powered serial ports. Some Point of Sale devices use a powered serial port. If the serial
port is configured as a powered port, devices that support a powered serial interface do not require an
external power source.
NOTE:
The computer ships with all serial ports configured in standard serial mode by default unless
the powered serial port AV numbers are ordered.
The serial port jumpers on the system board are located as shown in the following illustration:
Removing the Powered Serial Port Caps
Powered Serial Ports — Removal and Installation
53
Advertisement
Table of Contents
