Computer Setup-Security - HP Rp3000 - Point of Sale System Reference Manual

Computer Setup—Security
Table 2-4 Computer Setup—Security
Option
Setup Password
Power-On Password
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Device Security
Network Service Boot
Description
Allows you to set and enable setup (administrator) password.
NOTE: If the setup password is set, it is required to change Computer Setup options, flash the
ROM, and make changes to certain plug and play settings under Windows.
See the Troubleshooting Guide on the Documentation and Diagnostics DVD for more information.
Allows you to set and enable power-on password. The power-on password prompt appears after a
power cycle. If the user does not enter the correct power-on password, the unit will not boot.
NOTE: This password does not appear on warm boots , such as
from Windows, unless enabled in Password Options, below.
See the Troubleshooting Guide on the Documentation and Diagnostics DVD for more information.
Allows you to:
●
Lock legacy resources (appears if a setup password is set)
● Enable/disable network server mode (appears if a power-on password is set)
●
Specify whether the password is required for warm boot
on password is set)
●
Enable/Disable Setup Browse Mode (appears if a setup password is set) (allows viewing, but
not changing, the F10 Setup Options without entering setup password)
See the Desktop Management Guide on the Documentation and Diagnostics DVD for more
information.
Allows you to set Device Available/Device Hidden for
● Serial Port A
●
Serial Port B
●
Serial Port C (if an optional serial port expansion card is installed)
● Serial Port D (if an optional serial port expansion card is installed)
● All USB Ports
●
System Audio
● Network Controller (some models)
Enables/disables the computer's ability to boot from an operating system installed on a network
server. (Feature available on NIC models only; the network controller must be either a PCI expansion
card or embedded on the system board.)
Ctrl + Alt + Delete or Restart
(Ctrl + Alt + Delete) (appears if a power-
Computer Setup (F10) Utilities 9