Modem (Some Models) - HP Rp3000 - Point of Sale System Reference Manual
Service reference guide: hp rp3000 point of sale
Hide thumbs
Also See for Rp3000 - Point of Sale System:
- Troubleshooting manual (65 pages) ,
- Hardware reference manual (57 pages) ,
- Quickspecs (39 pages)
Table of Contents
Advertisement
5.
Squeeze the switch holder retaining clips together at the front of the chassis (1), push the LEDs
(2) and switch assembly into the chassis, and then remove the assembly from the chassis.
Figure 6-47
6.
Raise the drive cage to its upright position.
7.
Disconnect the cable assembly from the system board.
8.
Remove the assembly from the chassis.
To reinstall the power switch/LED assembly, reverse the removal procedure.
Modem (some models)
1.
Prepare the computer for disassembly
2.
Remove the computer cover
3.
Position the computer with the rear facing toward you.
4.
Raise the drive cage to its upright position.
5.
Remove the two screws that secure the modem to the system board, and then lift the modem
straight up and off the system board.
Figure 6-48
68
Chapter 6 Removal and Replacement Procedures
Removing the Switch Holder
(Computer Cover on page
Removing the Modem
(Preparation for Disassembly on page
38).
34).
Advertisement
Table of Contents
