HP Rp3000 - Point of Sale System Reference Manual page 65
Service reference guide: hp rp3000 point of sale
Hide thumbs
Also See for Rp3000 - Point of Sale System:
- Troubleshooting manual (65 pages) ,
- Hardware reference manual (57 pages) ,
- Quickspecs (39 pages)
Table of Contents
Advertisement
d.
To install the Powered Serial Port Expansion Card, align the bracket on the card with the open
slot on the rear of the chassis and press the card straight into the expansion socket (1).
Replace the screw that secures the card to the chassis (2).
NOTE:
When installing an expansion card, press firmly on the card so that the whole
connector seats properly in the expansion card slot.
Figure 6-32
e.
Connect the data cable to the riser card (1) and the expansion card (2). Connect the power
cable to the expansion card (3).
Figure 6-33
5.
Replace the computer cover.
6.
If the serial ports are configured in powered mode, connect the powered Point of Sale device.
HP offers two preconfigured serial port jumper configurations by selecting one of the following two AV#'s
when you order the platform.
Installing the Powered Serial Port Expansion Card
Connecting Data and Power Cables to the Powered Serial Port Expansion Card
Powered Serial Ports — Removal and Installation
57
Advertisement
Table of Contents
