Serial port assembly
A removable serial port can be installed on the back of the computer.
To remove the serial port assembly:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the drive cage
4.
From the outside of the chassis, remove the two nuts that secure the assembly to the rear of the
computer.
5.
From the inside of the chassis, disconnect the cable from the system board connector labeled COMB (1).
6.
Pull the serial port assembly away from the rear of the computer to remove it (2).
To install the serial port connector assembly, reverse the removal procedures.
54
Chapter 4 Removal and replacement procedures: Small Form Factor
(Preparation for disassembly on page
(Access panel on page
(Drive cage on page
25).
21).
20).