Power Supply - HP Rp3000 - Point of Sale System Reference Manual

To reinstall the cover sensor, reverse the removal procedure.
NOTE: The cable plugs into the left two pins in the connector labeled PB/LED and it does not matter
how you orientate the wire onto the connector.

Power Supply

WARNING!
active AC outlet. To avoid possible personal injury and damage to the equipment the power cord should
be disconnected from the computer and/or the AC outlet before opening the computer.
1. Prepare the computer for disassembly
2. Remove the computer cover
3. Position the computer with the rear facing toward you.
4. Remove the riser card cage
5. Rotate the drive cage up.
6. Disconnect the power cables from all of the drives and system board connectors.
7. Remove the three black T15 screws on the back of the power supply that secure it to the chassis.
Figure 6-51
70 Chapter 6 Removal and Replacement Procedures
Voltage is always present on the system board when the computer is plugged into an
(Computer Cover on page
PCI Riser Card Cage Assembly on page
Removing the Rear Power Supply Screws
(Preparation for Disassembly on page
38).
34).
48.