Interrupt Send - Kyocera KM-2560 Operation Manual

FAX Operation (Application)

Interrupt Send

4-8
During communication, when you scan originals by selecting direct
transmission, you can use interrupt send. Even when the communication
is prolonged due to broadcast transmission or a next transmission being
scheduled, the machine will first send originals for which interrupt send has
been set.
NOTE:
When the number of standby transmissions and delayed
transmissions has already reached 200, you cannot use interrupt send.
Depending on the timing of the interruption, you may not be able to
interrupt transmission immediately.
1 Press the Send key.
2
Load the originals to be sent using Interrupt Send.
3
Press [Advanced Setup], and then [FAX Direct Transmission].
4
Press [On].
5 Press [OK].
6
Set the destination, and press the Start key. The originals are left in queue,
and the transmission will start when transmission becomes possible.
NOTE:
For operation of direct transmission, refer to Selection of
Transmission Method on page 3-2.
To cancel transmission while waiting for interrupt send, press the Stop key
on the operation panel or [Cancel] on the touch panel. For details, refer to
Cancelling Communication on page 3-13.
7 When the interrupt send is completed, the canceled communication and
standby transmission will automatically resume.
Ready to directly transmit FAX.
Enter Destination.
FAX Direct Transmission
Send FAX directly, without reading o riginal
into memory. FAX can also be sent
page by page, with confirmation
Press [OK] to display after each page.
the image.
Off
Add Sho rtcut
Status
Destinatio n
0
On
Cancel OK
6/6/2006 10:00
OPERATION GUIDE