Supervisor Modules - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Chapter 1 Product Overview
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Supervisor-2 Modules
The Cisco MDS 9500 Series offers redundant, hot-swappable, Supervisor-2 modules. (See
Supervisor-2 modules can be used in the Cisco MDS 9509 and 9506 Directors in slots 5 and 6.
Supervisor-2 modules must be used in slots 7 and 8 of the Cisco MDS 9513 Director.
Supervisor-2 modules provide an integrated crossbar switching fabric to connect all the switching
modules when used in a Cisco MDS 9509 or 9506 Director. Single fabric configurations provide
720-Gbps full duplex speed with 80-Gbps full duplex bandwidth per switching module. Dual fabric
configurations provide 1.4-Tbps speed with 160-Gbps full duplex bandwidth per switching module. This
integrated crossbar switching fabric is disabled when a Supervisor-2 module is installed in a Cisco MDS
9513 Director. The Cisco MDS 9513 Director supports two external crossbar modules located at the rear
of the chassis that handle this function. (For more information, see the
page
Figure 1-12
1 Status, System, Active, and Power
2 Reset button
3 Console port
4 MGMT 10/100/1000 Ethernet port
5 COM1 serial port
1. See
The main functions and components of the Supervisor-2 modules are as follows:
•
•
•
•
OL-17467-02
1-25.)
Cisco MDS 9500 Series Supervisor-2 Module
3
4 5
1
2
1
Management LEDs
(with integrated Link and Activity
LEDs)
Table 1-4 on page 1-20 for status LED descriptions.
Control and Management
Processor
Port Interfaces
LEDs on the Supervisor-2 Module
7 8
6
6
CompactFlash LED
7
CompactFlash eject button
8 CompactFlash slot
9 USB ports
Cisco MDS 9500 Series Hardware Installation Guide

Supervisor Modules

Figure 1-12.)
"Crossbar Modules" section on
9
1-17