Rebooting A Switch; Overview Of Supervisor Modules - Cisco Nexus 9508 NX-OS Hardware Installation Manual

Managing the Switch
Step 1
Use the configure terminal command to enter the global configuration mode.
Example:
switch# configure terminal
switch(config)#
Step 2
Use the reload module slot_number command to specify the slot number of the module to reset.
Example:
switch(config)# reload module 4
This command will reload module 4. Proceed[y/n]?
reloading module 4 ...
switch(config)#

Rebooting a Switch

You can reboot or reload the switch by using the reload command without any options.
Note
Step 1 Use the configure terminal command to enter the global configuration mode.
Example:
switch# configure terminal
switch(config)#
Step 2 Use the copy running-config startup-config command to save the running configuration.
Example:
switch(config)# copy running-config startup-config
Step 3
Use the reload command to reload the switch.
Example:
switch(config)# reload

Overview of Supervisor Modules

The switch has one or two supervisor modules of the following types:
If you use the reload command, be sure to save the running configuration first by using the copy
running-config startup-config command.
[n] y
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide

Rebooting a Switch

65