Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 172

Migration Procedures for the MDS 9513 Director
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
switch# show module
Mod
---
7
8
switch# out-of-service xbar 1
Enter the show module xbar command to verify that the standby supervisor module is powered down.
Step 5
Attach a ESD wrist strap according to the instructions in the section
Step 6
Damage" section on page
Confirm that the LED light is red, which indicates that the module is powered off, and then loosen the
Step 7
two captive screws on the module being removed.
Remove the module from the chassis as follows:
Step 8
a.
b.
Cisco MDS 9500 Series Hardware Installation Guide
A-6
Ports Module-Type
----- -------------------------------- ------------------ ------------
0 Supervisor/Fabric-2
0 Supervisor/Fabric-2
2-19.
Place your thumbs on the top and bottom ejector levers and simultaneously rotate the levers outward
to unseat the module from the midplane connector. (See
Hold the front edge of the module and slide the module partially out of the slot. Do not touch the
module circuitry.
Appendix A Migrating to Generation 3 8-Gbps Fibre Channel Switching Modules
Model
DS-X9530-SF2-K9
DS-X9530-SF2-K9
Figure
Status
ha-standby
active *
"Preventing Electrostatic Discharge
A-1)
OL-17467-02