Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 174

Migration Procedures for the MDS 9513 Director
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure A-2
c.
Caution
d.
Note
e.
Verify that the LED light on the front of the module is green. The light should come on within five
Step 12
seconds of the module being inserted. If it does not, check to see if the module is seated correctly in the
slot.
Enter the system switchover command to put the other supervisor in active mode.
Step 13
Cisco MDS 9500 Series Hardware Installation Guide
A-8
Installing a Fabric Module
Grasp the two ejector levers using the thumb and forefinger of each hand, and press down to create
a small 0.040-inch (1-mm) gap between the module's EMI gasket and the module above it.
Do not press down too forcefully on the levers because they can bend.
While pressing down, simultaneously close the top and bottom ejector levers to completely seat the
module in the midplane connector. The ejector levers are completely closed when they are flush with
the front of the module.
Ensure that the ejector levers are completely closed before tightening the captive screws. Failure
to completely seat the module in the backplane connector can result in error messages.
Tighten the two captive screws on the module until they are finger tight.
Appendix A Migrating to Generation 3 8-Gbps Fibre Channel Switching Modules
OL-17467-02