Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 210

Cisco mds 9500 series hardware installation guide (ol-17467-02, october 2008)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

Cisco MDS 9500 Shelf Bracket
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Rack-Mounting Guidelines
If the rack is on wheels, ensure that the brakes are engaged or the rack is otherwise stabilized.
Caution
Before rack-mounting the chassis, ensure that the cabinet or the rack meets the following requirements:
Before Installing the Shelf Brackets
Before installing the shelf brackets, check the contents of your kit.
optional shelf bracket kit.
Table C-3
Quantity
2
16
12
12
Required Equipment
You need the following equipment for this installation:
Cisco MDS 9500 Series Hardware Installation Guide
C-14
The specifications listed in the
The depth of the rack between the front-mounting and rear-mounting rails is fixed at 18 inches
(45.7 cm).
The depth of the rack between the front-mounting and rear-mounting rails is fixed at 26.56 inches
(67.4 cm) for a Cisco MDS 9513 Director.
The cabinet or rack-mounting rails are nonthreaded.
The airflow and cooling are adequate and there is sufficient clearance around the air vents on the
Cisco MDS 9509 Director, as described in
particularly important to verify if you are installing the switch in an enclosed cabinet.
The rack has sufficient vertical clearance for the chassis and any desired clearance for the
installation process. The Cisco MDS 9500 Shelf Bracket Kit does not consume any RU when
installed.
The rack meets the minimum rack load ratings of 45 lb (20.41 kg) per rack unit (RU) for the Cisco
MDS 9509 Director.
Contents of Cisco MDS 9500 Shelf Bracket Kit
Part Description
Shelf brackets
1/4-20 x 3/4 in. Phillips pan-head screws with lock washers
10-32 x 1/3 in. Phillips pan-head screws with lock washers
10-32 clip nuts
Number 2 Phillips screwdriver
Tape measure and level (to ensure shelf brackets are level)
"Cabinet and Rack Requirements" section on page
Appendix D, "Technical Specifications."
Appendix C
Cabinet and Rack Installation
C-1.
This is
Table C-3
lists the contents of the
OL-17467-02

Advertisement

Table of Contents
loading

Table of Contents