Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 185

Chapter B Connecting the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure B-2
To connect the COM1 port to a modem, follow these steps:
Step 1 Connect the modem to the COM1 port using the adapters and cables provided with the accessory kit, as
follows:
a.
b.
c.
OL-17467-02
Connecting to the COM1 Port on the Supervisor Module for the Cisco MDS 9500
Series
Connect the DB-9 serial adapter to the COM1 port.
Connect the RJ-45 to DB-25 modem adapter to the modem.
Connect the adapters using the RJ-45 to RJ-45 rollover cable (or equivalent crossover cable).
Cisco MDS 9500 Series Hardware Installation Guide
Connecting to the COM1 Port
B-5