Services Modules; 18/4-Port Multiservice Module - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Cisco mds 9500 series hardware installation guide (ol-17467-02, october 2008)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

Chapter 1
Product Overview
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Services Modules

The Cisco MDS 9500 Series supports the following hot-swappable Generation 1 services modules:
Note
The internal bootflash installed on the modules are not field-replaceable units. Do not remove or replace
internal bootflash on the modules. Modifying the factory installed bootflash is not supported.

18/4-Port Multiservice Module

The Cisco MDS 9000 Family 18/4-port Multiservice (MSM-18/4) module provides 18 autosensing 1-,
2-, and 4-Gbps Fibre Channel ports and four Gigabit Ethernet IP services ports. The MSM-18/4 module
provides multiprotocol capabilities such as Fibre Channel, Fibre Channel over IP (FCIP), Small
Computer System Interface over IP (iSCSI), IBM Fiber Connectivity (FICON), and FICON Control Unit
Port (CUP) management.
The MSM-18/4 module provides18 4-Gbps Fibre Channel interfaces for high-performance SAN and
mainframe connectivity and four Gigabit Ethernet ports for FCIP and iSCSI storage services. Individual
ports can be configured with hot-swappable shortwave, longwave, extended-reach, coarse
wavelength-division multiplexing (CWDM) or dense wavelength-division multiplexing (DWDM) Small
Form-Factor Pluggables (SFPs) for connectivity up to 125 miles (200 km).
The MSM-18/4 module can minimize latency for disk and tape through FCIP write acceleration and
FCIP tape write and read acceleration. The MSM-18/4 module provides up to 16 virtual Inter-Switch
Link (ISL) connections on the four 1-Gigabit Ethernet ports through tunneling, and provides up to 4095
buffer-to-buffer credits that can be assigned to a single Fibre Channel port.
The MSM-18/4 supports hardware-based encryption and it is required to run the Storage Media
Encryption (SME) which, is a part of the Cisco NX-OS. For more information on SME, see the Cisco
MDS Storage Media Encryption Guide.
The MSM-18/4 supports SAN extension over IP and is compatible with current SAN extension products,
such as MPS-14/2, 9216i, and IPS. The MSM-18/4 provides an integrated next generation 4-Gbps FC
platform for SAN extension. The MSM-18/4 module supports Internet Protocol version 6 (IPv6) as
mandated by the U.S. Department of Defense (DoD), Japan, and China. The IPv6 support is provided
for FCIP, iSCSI, and management traffic routed in-band and out-of-band.
The MSM-18/4 provides intelligent diagnostics, protocol decoding, and network analysis tools with the
integrated Call Home capability.
OL-17467-02
18/4-Port Multiservice Module, page 1-41
18/4-Port Multiservice Federal Information Processing Standards Module, page 1-42
14/2-Port Multiprotocol Services Module, page 1-44
IP Storage Services Modules, page 1-46
32-Port Fibre Channel Advanced Services Module, page 1-48
32-Port Fibre Channel Storage Services Module, page 1-50
Caching Services Module, page 1-52
Cisco MDS 9500 Series Hardware Installation Guide
Services Modules
1-41

Advertisement

Table of Contents
loading

Table of Contents