Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 133

Chapter 2 Installing the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Caution
Grasp the power supply handles and slide the power supply partially out of the chassis, about four to five
Step 5
inches. (See
If the power supply is at your waist or chest level, place your other hand underneath the power supply
Step 6
and slide the power supply completely out of the chassis. Use the two front handles if you are
comfortable doing so.
Note
Figure 2-28
If the power supply is above your waist or chest height, use the lower front handle on the face plate and
Step 7
the other hand underneath the power supply. Assure adequate support with both hands on the unit at the
designated support points, and slowly pull the power supply out of the chassis so that the weight of the
unit will be fully supported once it is removed.
OL-17467-02
Use both hands to install and remove power supplies. Each power supply weighs 34.2 lbs (15.5
kg).
Figure 2-28.)
There is a handle at the top rear of the power supply you can also use to lift the power supply
out of the chassis.
Handling a Power Supply for the Cisco MDS 9513 Director
Removing and Installing a Power Supply or PEM
Cisco MDS 9500 Series Hardware Installation Guide
2-53