Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 135

Chapter 2 Installing the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure 2-29
2
1 Power supply switch
Grasp the power supply handles, one with each hand. Orient the power supply and align it with the bay.
Step 4
Note
Step 5 Slide the power supply into the power supply bay. Ensure that the power supply is fully seated in the bay.
Secure all four 6-32 panel fasteners and tighten to 8 in-lbs.
Step 6
Plug the power cable into the power supply, and tighten the screw on the cable retention device to ensure
Step 7
that the cable cannot be pulled out.
Step 8 Connect the other end of the power cable to an AC power source.
Turn the power switch to the on (|) position on the power supply.
Step 9
Verify power supply operation by checking that the power supply LEDs are in the following states:
Step 10
•
•
•
OL-17467-02
AC Power Supply for the Cisco MDS 9513 Director
2
There is a handle at the top rear of the power supply you can also use to tilt the power supply
into the bay.
INPUT OK LEDs are green.
FANs OK LED is green.
OUTPUT FAIL LED is off.
Removing and Installing a Power Supply or PEM
1
2 Power cable retainer
Cisco MDS 9500 Series Hardware Installation Guide
2-55