Troubleshooting The Switching Module; Troubleshooting Supervisor Modules - Cisco Catalyst 9400 Series Troubleshooting Manual

Troubleshooting the Switching Module

Troubleshooting the Switching Module
Each switching module has one STATUS LED that provides information about the module and one numbered
PORT LINK LED for each port on the module. Refer to
to determine the status of the LEDs.
Useful Cisco IOS Commands - Switching Modules
The show module command provides information that is useful in solving problems with ports on individual
modules.
Some problems can be solved by resetting the switching module. Power cycle the chassis - this resets, restarts,
and power cycles the switching module.

Troubleshooting Supervisor Modules

This section only addresses problems with hardware. Problems with features or configuration are not covered
here. Refer for your software configuration guide and release notes for information on configuring features
or identifying known problems.
Supervisor Module LEDs
• Check the LEDs on your supervisor and compare them to the described LED behaviors. See
• The Supervisor Module STATUS LED turns either amber or red under the following conditions:
Standby Supervisor Engine Problems
•
• Make sure that the supervisor module properly seats in the backplane connector and that you have
•
Troubleshooting
10
Catalyst 9400 Series Supervisor Module LEDs
• Power supply failure (not the same as removal of power supply)
• Power supply fan failure
• Removal or failure of fan tray
• Mismatched power supplies in the chassis
Switch# show module
If the standby supervisor module is not online or status indicates "other" or "faulty" in the output of the
show module command or an amber status LED, create a console connection to the standby supervisor
and check if it is in ROMMON mode or in continuous reboot. If the standby supervisor is in either of
these two states, refer to the System Management > Troubleshooting the Software Configuration section
of the Software Configuration Guide
completely screwed down the captive screws for the supervisor module.
Switch# redundancy reload peer
Cisco Catalyst 9400 Series Switching Module LEDs
Troubleshooting
Cisco