Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 219

Appendix D Technical Specifications
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
•
If a 110 VAC input is chosen, a 110-VAC power cord (CAB-7513AC=) must be ordered separately.
Power output does not include the power used by the individual modules used in the chassis.
Note
Table D-8
Table D-8
Description
6000-W AC Power Supply
Type
Voltage
Current rating
Frequency
Output capacity
Output voltage at 110/120 3.3 V at 10 A, 50 V at 57 A
Output voltage at 200/240 3.3 V at 10A, 50 V at 119 A
Component Power Requirements and Heat Dissipation for the Cisco MDS 9513
Director
Consider heat dissipation when sizing the air-conditioning requirements for an installation. The power
and heat associated with a Cisco MDS 9513 Director varies based upon the following considerations:
•
•
•
Table D-9
Director.
Unless noted otherwise, the data listed in
Note
are approximately 30 percent below the numbers listed here.
OL-17467-02
Two AC power connection @ 220 VAC = 6000 W output
lists the specifications for the Cisco MDS 9513 power supplies.
Specifications for Cisco MDS 9513 Power Supplies
Specification
Autoranging input with power factor corrector.
100 to 240 VAC (±10%).
16 A maximum at 100 to 120 VAC and 2900-W output.
16 A maximum at 200 to 240 VAC and 6000-W output.
50 to 60 Hz (nominal) (±3 Hz for full range).
One AC power connection @110 VAC = No output
Two AC power connection @110 VAC = 2900 W output
One AC power connection @ 220 VAC = 2900 W output
One AC power connection @110 VAC and one AC power connection
@ 220 VAC = 2900 W output
Two AC power connection @ 220 VAC = 6000 W output
Power supply type
Switching module type and number of switching modules installed
Average switching traffic levels
lists the power requirements and heat dissipation for the components of the Cisco MDS 9513
Power Specifications for the Cisco MDS 9513 Director
Table D-9 is based on worst-case conditions. Typical numbers
Cisco MDS 9500 Series Hardware Installation Guide
D-7