Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 112

Starting Up the Switch
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure 2-19
connector. The power connector is provided on the PEM. The AC and DC power supplies are similar in
appearance except for the label, which indicates whether it is AC or DC.
Figure 2-19
1 Power supply LEDs
To provide power to an AC power supply in a Cisco MDS 9509 Director or a Cisco MDS 9506 Director,
follow these steps:
Plug the power cable into the switch as follows:
Step 1
•
Note
•
Connect the other end of the power cable to a power source.
Step 2
Note
Cisco MDS 9500 Series Hardware Installation Guide
2-32
shows a power supply for a Cisco MDS 9506 Director. The power supply has no power
Power Supply for Cisco MDS 9506 Director
2
2 Captive screws
For the Cisco MDS 9509 Director, plug the power cable into the power supply and tighten the screw
on the power cable retainer to ensure that the cable cannot be pulled out.
The 4000-W AC power supply for the Cisco MDS 9509 Director has a permanent power cable
attached.
For the Cisco MDS 9506 Director, plug the power cable into the AC PEM on the front of the chassis.
Depending on the outlet receptacle on your power distribution unit, you may need the optional
jumper power cord to connect the Cisco MDS 9500 Series director to your outlet receptacle. See
the "Jumper Power Cord" section on page
1
E-11.
Chapter 2 Installing the Cisco MDS 9500 Series
OL-17467-02