Installing A Clock Module Into The Cisco Mds 9509 Director; Removing A Clock Module From The Cisco Mds 9506 Director - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Cisco mds 9500 series hardware installation guide (ol-17467-02, october 2008)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

Chapter 2
Installing the Cisco MDS 9500 Series
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Installing a Clock Module into the Cisco MDS 9509 Director

Always wear an ESD wrist strap when handling modules or coming into contact with internal
Caution
components.
To install the clock module, follow these steps:
Step 1
Remove the new clock module from the antistatic bag.
Hold the module with the connectors away from you.
Step 2
Carefully press the module onto the two matching connectors on the backplane.
Step 3
Note
Replace the four screws to secure the clock module onto the backplane.
Step 4
Repeat
Step 5
Replace the back panel safety cover using the 18 screws.
Step 6
Provide power to the power supplies as described in the
Step 7
page
Caution
Step 8
Verify power supply operation by checking that the power supply LEDs are in the following states:

Removing a Clock Module from the Cisco MDS 9506 Director

Before replacing the clock module, check the contents of your kit.
clock module replacement kit, part number DS-C9506-CL=.
Table 2-7
Quantity
1
12
1
OL-17467-02
You must install the new clock module in the same position that you removed it.
Step 1
through
Step 4
to install any additional clock modules.
2-28.
In a system with dual power supplies, connect each power supply to a separate power source.
In case of a power source failure, the second source will most likely still be available.
INPUT OK LED is green.
FAN OK LED is green.
OUTPUT FAIL LED is off.
Contents of Cisco MDS 9506 Clock Module Replacement Kit
Part Description
Cisco MDS 9506 clock module
M3 x 6-mm Phillips pan-head screws
Disposable ESD wrist strap
Removing and Installing Clock Modules
"Connecting the Power Supplies" section on
Table 2-7
Cisco MDS 9500 Series Hardware Installation Guide
lists the contents of the
2-83

Advertisement

Table of Contents
loading

Table of Contents