Removing A Clock Module From The Cisco Mds 9509 Director - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Removing and Installing Clock Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
•

Removing a Clock Module from the Cisco MDS 9509 Director

Before installing the clock module, check the contents of your kit.
clock module replacement kit, part number DS-C9509-CL=.
Table 2-6
Quantity
1
12
1
These tools are required to remove or install a clock module:
•
•
Clock modules are connected to the rear of the Cisco MDS 9509 Director using two connectors.
Figure 2-43
removed.
Figure 2-43
Cisco MDS 9500 Series Hardware Installation Guide
2-80
OUTPUT FAIL LED is off.
Contents of Cisco MDS 9509 Clock Module Replacement Kits
Part Description
Cisco MDS 9509 clock module
M3 x 6-mm Phillips pan-head screws
Disposable ESD wrist strap
Number 1 Phillips screwdriver
Your own ESD-prevention equipment or the disposable grounding wrist strap included with all
upgrade kits, field-replaceable units (FRUs), and spares
shows the clock modules in a rear view of the Cisco MDS 9509 Director with the back panel
Clock Module Location on the Cisco MDS 9509 Director (Rear View)
1
2
Cisco MDS 9509
Chapter 2 Installing the Cisco MDS 9500 Series
Table 2-6 lists the contents of the
OL-17467-02