Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual page 42

Supervisor Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Table 1-4
LED
Status
System
Active
Power
Management
MGMT
10/100/1000
Ethernet Link
LED
MGMT 10/100
Ethernet
Activity LED
CompactFlash
Cisco MDS 9500 Series Hardware Installation Guide
1-20
LEDs for the Cisco MDS 9500 Series Supervisor-2 Modules
Status Description
Green All diagnostics pass. The module is operational
(normal initialization sequence).
Orange One of the following occurs:
• The module is booting or running diagnostics
(normal initialization sequence).
• An over-temperature condition occurred (a minor
threshold was exceeded during environmental
monitoring).
Red One of the following occurred:
• The diagnostic test failed. The module is not
operational because a fault occurred during the
initialization sequence.
An over-temperature condition occurred (a major
•
threshold was exceeded during environmental
monitoring).
Green All chassis environmental monitors are reporting OK.
Orange One of the following occurred:
The power supply failed or the power supply fan
•
failed.
Incompatible power supplies are installed.
•
The redundant clock failed.
•
Red The temperature of the supervisor module exceeded
the major threshold.
Green The Supervisor-2 module is operational and active.
Orange The Supervisor-2 module is in standby mode.
Green Sufficient power is available for all modules.
Orange Sufficient power is not available for all modules.
Green Link is up.
Off No link.
Green Traffic is flowing through port.
Off No link or no traffic.
Green The external CompactFlash card is being accessed.
Off No activity.
Chapter 1 Product Overview
OL-17467-02