Removing, Installing, And Verifying Supervisor, Switching, And Services Modules - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Removing, Installing, and Verifying Supervisor, Switching, and Services Modules

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Note
Verify that the system software has booted and the switch has initialized without error messages. If any
Step 11
problems occur, see the Cisco MDS 9000 Family Troubleshooting Guide or the Cisco MDS 9000 Family
System Messages Reference. If you cannot resolve an issue, contact your customer service
representative.
Complete the worksheets provided in
Step 12
reference.
Note
Removing, Installing, and Verifying Supervisor, Switching, and
Services Modules
This section provides the following information:
•
•
•
•
•
•
•
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments. Statement 1051
Warning Use of controls, adjustments, or performing procedures other than those specified may result in
hazardous radiation exposure. Statement 1057
Warning Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing. Statement 1034
Cisco MDS 9500 Series Hardware Installation Guide
2-38
If you purchased this product through a Cisco reseller, contact the reseller directly for technical
support. If you purchased this product directly from Cisco Systems, contact Cisco Technical
Support at this URL: http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml.
A setup utility automatically launches the first time you access the switch and guides you
through the basic configuration. For instructions about how to configure the switch and check
module connectivity, see the Cisco MDS 9000 Family CLI Configuration Guide or the Cisco
MDS 9000 Family Fabric Manager Configuration Guide.
Removing Supervisor Modules, page 2-39
Installing Supervisor Modules, page 2-40
Removing a Caching Services Module, page 2-44
Removing Other Switching and Services Modules, page 2-45
Installing a Switching or Services Module, Including Caching Services Modules, page 2-45
Verifying Installation of Supervisor, Switching, and Services Modules, page 2-46
Removing and Installing a Crossbar Module, page 2-47
Chapter 2
Appendix F, "Site Planning and Maintenance Records,"
Installing the Cisco MDS 9500 Series
for future
OL-17467-02