Removing And Installing Switching And Services Modules - Cisco MDS 9216 Hardware Installation Manual

Removing and Installing Components
Send documentation comments to mdsfeedback-doc@cisco.com.

Removing and Installing Switching and Services Modules

Warning
Warning
Warning
Caution
Note
Cisco MDS 9216 Switch Hardware Installation Guide
2-22
This section describes how to install a switching or services module in slot 2 of
the Cisco MDS 9216 Switch. Slot 1 is reserved for the supervisor module with its
integrated 16-port switching module. Slot 2 can contain an optional 16-port or
32-port switching module or a services module such as an 8-port IPS module. See
Figure 1-1 for slot locations.
This section provides the following information:
• Removing a Switching or Services Module from Slot 2, page 2-25
• Installing a Switching or Services Module in Slot 2, page 2-25
Verifying Installation of a Switching or Services Module in Slot 2, page 2-27
•
Invisible laser radiation may be emitted from disconnected fibers or
connectors. Do not stare into beams or view directly with optical instruments.
Statement 1051
Use of controls, adjustments, or performing procedures other than those
specified may result in hazardous radiation exposure. Statement 1057
Hazardous voltage or energy is present on the backplane when the system is
operating. Use caution when servicing. Statement 1034
To prevent ESD damage, wear grounding wrist straps during these procedures and
handle modules by the carrier edges only.
Install the Cisco MDS 9216 Switch in the rack before installing modules. For
information about installing the chassis, see the
Rack" section on page
Chapter 2
2-7.
Installing the Cisco MDS 9216 Switch
"Installing the Chassis in the
78-16165-01