Removing And Installing Components; Removing And Installing Switching And Services Modules - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Removing and Installing Components

Note
Verify that the system software has booted and the switch has initialized without error messages. If any
Step 10
problems occur, see the Cisco MDS 9000 Family Troubleshooting Guide or the Cisco MDS 9000 Family
System Messages Guide. If you cannot resolve an issue, contact your customer service representative.
Complete the worksheets provided in
Step 11
reference.
A setup utility automatically launches the first time you access the switch and guides you through the
Note
basic configuration. For instructions on how to configure the switch and check module connectivity, see
the Cisco MDS 9000 Family CLI Configuration Guide or the Cisco MDS 9000 Family Fabric Manager
Configuration Guide.
Removing and Installing Components
This section includes the following topics:
•
•
•
•
•
Warning Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing.
Caution To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by
the carrier edges only.

Removing and Installing Switching and Services Modules

Slot 1 is reserved for the supervisor module with its integrated multiport switching or IP services
module. Slot 2 can contain an optional module. See
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments.
Cisco MDS 9200 Series Hardware Installation Guide
2-28
If you purchased this product through a Cisco reseller, contact the reseller directly for technical
support. If you purchased this product directly from Cisco, contact Cisco Technical Support at
this URL: http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml.
Removing and Installing Switching and Services Modules, page 2-28
Maintaining a Caching Services Module, page 2-35
Removing and Installing Power Supplies, page 2-36
Removing and Installing the Fan Module, page 2-38
Removing the Cisco MDS 9200 Series, page 2-40
Statement 1034
Chapter 2
Appendix D, "Site Planning and Maintenance Records"
Figure 1-2
Statement 1051
Installing the Cisco MDS 9200 Series
for slot locations.
for future
OL-16188-01