Main Menu> Advanced> Advanced Tools; Main Menu> Advanced> Advanced Tools> Software Upgrade - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

700 Series Software Manual v2.1
Menu choices are Per Port Lockdown or Table. You can enable lockdown of a specific port in the
Per Port Lockdown page. The Table page has two functions, which allow you to Remove or Query
entries from the MAC Address Lockdown Table.
Main Menu> Advanced> Advanced Tools
This menu provides you with the ability to upgrade the software for the switch as well as saving or
loading the switch configuration file to a TFTP server.
Main Menu> Advanced> Advanced Tools> Software Upgrade
If new improvements to the software that runs the switch become available, this menu enables you
to upgrade your switch to the new software release.
Figure 4-21: Software Upgrade
Once the IP address of the TFTP and the path location of the new software image file is properly
configured, you can choose to boot the switch using one of three options. Please refer to
3, "Software Upgrade Procedure"
• Net option:. This option allows you to try out a new image before upgrading. It requires a
TFTP filename and a server IP address to retrieve the specified image from the given IP
address. The new image will not overwrite the one in non-volatile memory.
• Net & save option.This option requires the same setup as the Net option, i.e. TFTP server and
a new image. However, it copies the image to non-volatile memory directly and then the
system boots from non-volatile memory.
• Warning: The previous image in non-volatile memory will be lost when the procedure
completes.
4-18
when updating software.
Administration Console Telnet Interface
Chapter