Spanning Tree - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

700 Series Software Manual v2.1

Spanning Tree

Spanning Tree Protocol (STP) ensures that only one path at a time is active between any two
network nodes. There are maybe more than two physical path between any two nodes for
redundant paths; STP ensures only one physical path is active and the others are blocked. STP will
prevent an inadvertent loop in a network, which can disable your network due to a "Broadcast
storm", the result of a broadcast message traveling through the loop again and again.
Forward Time
Use the
forward-time
Syntax
FSM726(config)# spanning-tree forward-time <interval>
Where
= the STP forward interval. This number ranges from 4 – 30 seconds.
<interval>
Hello Time
Use the
hello-time
Syntax
FSM726(config)# spanning-tree hello-time <interval>
Where
= the STP hello interval. This number ranges from 1 – 10 seconds.
<interval>
Max-Age
Use the command to set the STP maximum age interval.
max-age
Syntax
FSM726(config)# spanning-tree max-age <interval>
Where
= the STP max age interval. This number ranges from 6 – 40 seconds.
<interval>
6-26
to set the STP forward interval.
command to set the STP hello interval.
Command Line Interface