Ip-Filter - NETGEAR FSM726v2 - 10/100 Mbps Managed Switch Setup Manual

700 Series Software Manual v2.1
FSM726(config)# system config-tftp ip <IP address>
Where
= the IP address of the TFTP server.
<IP address>
Config-tftp Path/File
The
config-tftp path/file
configuration file to be loaded/saved.
Syntax
FSM726(config)# system config-tftp path/file <path&filename>
Where
<path&filename>
IP
The command lets you set the IP address of the switch.
IP
Syntax
FSM726(config)# system ip <IP address>
Where
= the IP address of the switch.
<IP address>

IP-Filter

The purpose of IP filtering is to prevent unauthorized personnel from gaining access to the switch.
This is accomplished by allowing only certain IP addresses to be able to access the management.
This command enables IP filtering on the switch. The No command will disable it.
Syntax
FSM726(config)# system ip-filter
6-28
command lets you configure the path and the filename of the
= the path and the filename of the file
Command Line Interface